EZ-ON 100TM User Manual

100TM
EMERGENCY RELEASE PROCEDURE
IMPORTANT INFO
• Meets FMVSS213.
• Use Only with EZ-ON Vests. Compatible Vest include: 303Z, 403PB.
• Install tether hardware kit if the passenger weight exceeds the vehicles tether anchor weight
determined by the vehicle manufacturer.
• Must use factory seatbelt.
• Use on school bus seats that have entry between the seat bottom and the seat back.
TETHER MOUNT (For Family Vehicle)
EMERGENCY CUTTING
When evacuating the passenger in a safety vest, the vest webbing is never cut. One cut of the mount
webbing above the anchor will allow the passenger to evacuate the vehicle wearing the safety vest
and one cut of the lap belt.
EZ-ON PRODUCTS
1-800-323-6598
www.ezonpro.com
WARRANTY
EZ-ON Products stands behind the products we make. Warranty covers any defects in material or workmanships under
normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.
WARNING
Death or serious injury can occur If manufacturer’s instructions are not followed correctly.
All EZ-ON products are dynamically tested to meet NHTSA standards. Please follow washing
instructions on product tag. Replace product if it is damaged, frayed, or has been in a crash.
Recommended replacement after six years.
EZ-ON Products are not liable for injury if these recommendations are not followed.

EZ-ON 100TM Specifications

General

Brand	EZ-ON
Model	100TM
Category	Automobile Accessories
Language	English

Summary

Important Information and Safety

Important Usage Information

Details key specifications like FMVSS213 compliance, compatible vests, and installation requirements for vehicle tether anchor weight.

Product Warranty Policy

Outlines EZ-ON Products' commitment to quality, covering defects for 1 year from the manufacturer date under normal use.

Critical Safety Warning

Highlights severe injury risk if instructions are not followed, emphasizing dynamic testing, proper care, and replacement guidelines.

Emergency Release Procedure

Describes the correct method for evacuating a passenger by cutting the mount webbing and lap belt, not the vest webbing.

100TM Tether Mount Installation

Locate and Attach Tether Anchor

Instructions for finding the vehicle's tether anchor bracket and connecting the tether mount's snap hook.

Position and Tighten Mount

Guidance on placing the 'Y' strap over the seat back and securing it using the tilt lock adjuster.

Secure Passenger and Reduce Slack

Steps to attach snap hooks to shoulder adjusters and reduce tether slack for a snug fit.

Vehicle Belt and Buckle

Instructions on threading the vehicle belt through vest loops and buckling it low on the lap.