Maintenance
Repairing a punctured tyre If you have a punctured tyre, we
recommend that you get a specialist to carry out the repairs. You
can always of course consult a specialist and carry out the repairs
on your own.
As the rear wheel contains the hub motor, there are additional
steps in the case you require the entire wheel to be removed from
the bike. Located on the underside of the bike, unplug the wires
than run from the motor to controller. There should be 1 x 6 pin
connection and 3 colour coded wire connections (Blue, Yellow,
Green). Unplug these before proceeding to remove the front wheel.
Be mindful of the tightening assembly sequence of washers, nuts
and spacers.
Hub motor and general inspection
After 5,000 kms (3,000 miles) of cycling. We recommend you
arrange to have a thorough inspection of your bicycle by an eZee
dealer. This includes opening up the hub motor to inspect and
lubricate the gears.
Electronic self-diagnostic system
When the bicycle is functioning normally, the red LED that is
situated by the controller is lit continually.
In the case of an electronic malfunction, the controller comes
programmed with diagnostic capabilities to determine where the
fault lies. The red LED will emit a series of blinks, count them and
refer to the table below for its explanation and solutions.
20
To Next Page
Loading...
