Required Tools (not included):
Scissors or wire cutters•
10mm open-end wrench (may be •
needed)
Included in your parts box:
Toolkit (4+5mm combo hex wrench, •
13+15mm combo open-end wrench)
Touch-up paint•
Reectors (if not already installed)•
Assembly will take about 30 minutess
Scooter won’t turn on (no lights
on throttle)
• 5-minute auto shutoff feature has activated; turn scooter off then
on again
• Battery not charged
• Battery may not be connected from factory. Remove your
scooter’s deck plate using the thumb screw under the on/off
switch, connect the battery, then replace the plate
• The scooter’s fuse may be blown. See your owner’s manual for
more information on locating and replacing this fuse, or call our
Customer Service line for help
Brakes rub when riding • Re-adjust the brakes, referring to the attached document. Do
not ride the scooter if the brake pads are rubbing the front tire.
Can someone help me with...? Call the Currie Technologies technical and customer service
department at 1-800-377-4532
Electrical System
Basic Troubleshooting
Currie Technologies Technical and
Customer Service
1.800.377.4532
Your electric scooter comes with a 24 volt sealed lead-acid (SLA) battery. This type of
battery does not have a memory, and riding on a partial charge will not affect its capacity
or performance (you can safely test ride the scooter after assembly, although it won’t be
fully charged.). Recommended charge time for this type of battery is 4-6 hours.
Assembly Guide
450 QSG V1 2011
Last modified April 27, 2011 3:14 PM
To Next Page
Need help?
General
