Ezytrail LINCOLN LX MK3

Questions and Answers

D
David MackAug 16, 2025
What to do if lights, plugs, or fridge not working on my Ezytrail LINCOLN LX MK3 Camping Equipment?
- K
  Kimberly HallAug 16, 2025
  If the lights, plugs, or fridge aren't working on your Ezytrail Camping Equipment, first, ensure the Main Power Switch is turned “ON”. Then, check the control panel to confirm the Circuit switch is also “ON”. Additionally, verify that the circuit breaker hasn't tripped and reset it if necessary. Tighten battery terminals and check all power connections to rule out poor connections. Also, make sure the Battery isolator switch is on. Finally, inspect for any damaged wiring and repair or replace it as needed.
J
John CoxAug 19, 2025
Why is my Ezytrail LINCOLN LX MK3 Camping Equipment battery not charging?
- R
  Robin FuentesAug 20, 2025
  If your Ezytrail Camping Equipment battery isn't charging, start by ensuring the charger is turned on and that there is mains power. If the charger still doesn’t switch on, it may be faulty, so contact your dealer for warranty or replacement. Also, check that the battery isolator switch is on and reset the breaker if it has tripped. If the charger has overheated, let it rest for 30 minutes and ensure it has adequate ventilation. A faulty charger will be indicated by fast flashing on the charger control panel, in this case, contact your dealer for warranty or replacement. Have the battery tested and replaced if faulty. Finally, tighten the battery terminals and check all power connections to rule out poor connection.
S
smorrisAug 22, 2025
How to fix no 12V power in my Ezytrail Camping Equipment?
- J
  Jessica JonesAug 22, 2025
  If you have no 12V power in your Ezytrail Camping Equipment, make sure the Main Power Switch is turned on. Also, ensure the Battery isolator switch is on. If that doesn't solve the problem, reset the main circuit breaker. Low battery voltage can also be a culprit, so charge the battery for 24 hours and retest. Poor connections can prevent power, so tighten the battery terminals and check all power connections. Lastly, inspect for any damaged wiring and repair or replace it.
M
Mary RamirezAug 25, 2025
What to do if pump not working (no noise) on my Ezytrail LINCOLN LX MK3?
- A
  Aaron CollierAug 26, 2025
  If the pump on your Ezytrail Camping Equipment isn't working and making no noise, first, ensure the Main Power Switch is turned on and that the Battery isolator switch is also on. Reset the main circuit breaker, if it has tripped. Low battery voltage can also cause this issue, so charge the battery for 24 hours and retest. Check and tighten the battery terminals and power connections to rule out poor connection. Inspect for any damaged wiring and repair or replace it. If none of these steps work, the pressure switch may be faulty; bypass it to test and replace if required.
C
Carlos BarberAug 27, 2025
Why is cooker not igniting on my Ezytrail Camping Equipment?
- A
  Amy FlowersAug 28, 2025
  If the cooker on your Ezytrail Camping Equipment is not igniting, try the following: * Replace the PIEZO Battery. * Fill the gas bottle if it's empty. * Turn on the valve on the gas bottle. * Check that the gas hose on the cooker is securely connected into the receiver. * Clean the stove of grease/dirt buildup. * Ensure the hose is not twisted and kinked. * If the regulator is blocked, get professional diagnosis and help.
J
Jeff WilsonAug 30, 2025
What causes circuit breaker tripping during use in my Ezytrail LINCOLN LX MK3?
- K
  krichardsAug 30, 2025
  If the circuit breaker in your Ezytrail Camping Equipment is tripping during use, it could be due to overloading. Check the amperage draw from appliances, then reset the breaker and check appliances individually. A faulty appliance can also cause this, so check each appliance individually and rectify any issues. Finally, the circuit breaker itself may be faulty, so test and replace it if necessary.
K
Kathleen CoxSep 2, 2025
Why is pump working but no water flow in my Ezytrail Camping Equipment?
- V
  Victoria CraneSep 2, 2025
  If the pump on your Ezytrail Camping Equipment is working but there's no water flow, there might be an airlock in the water lines. Try turning on the tap and holding your finger over the nozzle for 5 seconds, then release; repeat this several times. If that doesn't work, fill the water tank and use mains pressure to pressurize the tank. Also, ensure the water tank is not empty and fill it if needed. Check the hoses to make sure none are kinked. Finally, if the pump diaphragm is damaged or worn, consider repairing or replacing the pump.
H
Heidi BennettSep 4, 2025
What to do if indicators or park lights not working on my Ezytrail LINCOLN LX MK3 Camping Equipment?
- E
  Eric HarrisSep 4, 2025
  If the indicators or park lights on your Ezytrail Camping Equipment aren't working, first, connect the trailer plug. If that doesn't solve the issue, check and clean the plug contacts, and use a knife or small screwdriver to separate the split in the pin slightly if the pins are closed. Inspect the chassis wiring for damage and repair as required. Finally, check the supply vehicle for faults and rectify them.
A
anthony84Sep 7, 2025
Why are the brakes weak on my Ezytrail Camping Equipment?
- J
  Juan ValdezSep 7, 2025
  If your Ezytrail Camping Equipment has weak brakes, it could be due to several reasons. Grit or oil on the linings or magnets may be the cause, so clean or replace them. Corroded connections can also lead to weak brakes, so clean or replace the connectors. Worn linings or magnets should be replaced. If the brake drums are scored or grooved, machine or replace them. Poor synchronization requires correcting the controller setting, while poor brake adjustment requires adjusting the brakes. Glazed brake linings should be re-burnished or replaced. Finally, an overloaded trailer can affect braking, so correct the loading and check at a weighbridge.
I
iandersonSep 10, 2025
What causes brakes locking on my Ezytrail LINCOLN LX MK3?
- M
  Matthew BarnesSep 10, 2025
  If the brakes on your Ezytrail Camping Equipment are locking, it could be due to poor synchronizing with the controller, so adjust the controller. Poor adjustment can also cause locking, so adjust the brakes. A faulty controller may be the issue; test, rectify, or replace it. Inspect for loose, bent, or broken components and replace them. Lastly, insufficient wheel load on a dual axle setup can cause locking, so correct the trailer level to even the load.

Summary

Introduction

Terminology & Abbreviations

Defines key terms and abbreviations used in the manual for clarity.

Branch Locations

About Your Offroad Camper

Bearings and Seals

Details specifications and maintenance for bearings and seals.

How to Hitch Your Coupling

Coupling

Step-by-step guide on safely attaching the coupling to the towball.

Uncoupling

Step-by-step guide on safely detaching the coupling from the towball.

Canvas Care

Seasoning the Canvas

Instructions for the initial 'seasoning' process of the canvas tent.

Protecting Seams and Screens

Guidance on protecting tent seams and mesh screens from damage.

Zips

Tips for proper zipper usage and care to prevent damage.

Condensation

Explains the causes of condensation and how to reduce it.

Mould

Methods to prevent and deal with mould on the canvas.

Setting Up Your Camper

Loading Your Camper

Advice on distributing weight for optimal ball load balance.

Choosing a Spot to Set Up

Guidelines for selecting a suitable and safe campsite location.

Inside the Tent

Instructions for setting up the interior tent components.

Outside the Tent

Guidance on setting up the external parts of the camper tent.

Annexe Walls

Instructions for attaching and securing the annexe walls.

Lounge Mode

Bed Mode

Kitchen

Preparing for Bad Weather

Storage & Care

Long Term Storage

Recommendations for protecting the camper during long-term storage.

Interior

Advice on managing moisture and preventing mould inside the camper.

Exterior

Care instructions for external seals and components.

Care of Paint & Surfaces

Guidelines for cleaning and maintaining the camper's paint and surfaces.

Torque Settings

Wheel Nuts

Specifies torque settings and re-torquing intervals for wheel nuts.

Hitch

Details the correct torque for hitch bolts and inspection intervals.

Brakes and Handbrake

Brake Controller*

Explains the function and adjustment of the electric brake controller.

Trailer Plug Wiring

Diagrams for the correct wiring of 7-pin trailer plugs.

Breakaway Switch

Information on the breakaway system's function and mandatory charging.

Hand Brake

How to operate and adjust the mechanical handbrake.

Correct Use of Your Electric Brakes

Guidance on synchronising trailer and vehicle brakes for safe braking.

Brake Adjustment

Recommended intervals and procedures for brake adjustment.

Wheels and Tyres

Highway

Recommended tyre pressures for highway driving based on ATM.

Off Road

Advice on adjusting tyre pressures and speed for off-road conditions.

Jacking Your Camper

Details the location and correct procedure for jacking the camper.

Electrical Systems

Chargers

Information regarding the camper's chargers and electrical safety.

Battery Care

Guidelines for maintaining deep cycle batteries for optimal life.

Control Panel

Identifies and explains the functions of the camper's control panel.

Gas & Water Systems

Water Pumps

Explains how the water pump system operates.

Connecting the Gas

Step-by-step guide to connecting the gas bottle and stove.

Hot Water

Information on the camper's hot water system and safety.

Trip Checklist

Pre Hook Up

Checklist for essential tasks before hooking up the camper.

On The Move

Checklist for checks to perform while towing the camper.

Useful Accessories

Levelling Blocks

Explains the use of levelling blocks for trailer stability.

Wheel Chocks

Importance and correct usage of wheel chocks for safety.

Stone Protection

Devices to protect the trailer from stone damage.

Trouble Shooting

Electrical

Common electrical issues and their solutions.

Water

Troubleshooting common problems with the water system.

Gas

Solutions for issues related to the gas cooker not igniting.

Handy Tips

Preperation Time

Emphasizes planning and preparation for trips.

Driving Off Road

Advice and considerations for off-road towing.

Sand

Guidance on driving on sand, including tyre pressure adjustments.

Warranty Statement

Validity of Claims

Outlines the conditions under which warranty claims are valid.

Camper Trailers

Details warranty coverage for the camper trailer components.

Maintenance Schedule

Appendix

Appendix A - Pack Down

Step-by-step instructions for packing down the camper.