Need help?Do you have a question about the FAAC XGUARD-10 and is the answer not in the manual?
Details on laser diode types, safe usage, and warranty void conditions for unauthorized repairs.
Guidelines for proper installation and maintenance to ensure sensor longevity and performance.
Identification and description of the physical components of the XGUARD laser scanner.
Explanation of the various LED indicators and their meanings for operational status.
Explanation of symbols used in the manual, including safety, settings, and compliance.
Details on connecting the sensor's power supply and output relays according to wiring diagrams.
Instructions for activating laser beams and adjusting lateral and tilt angles for optimal detection.
Selecting the correct mounting side for environment learning and proper operation.
Specifications for detection range width and height for XGUARD-10 and XGUARD-5 models.
Procedure for the sensor to learn its surroundings and adapt the detection field shape.
Configuration options for activating or deactivating specific detection curtains.
Setting the width of the detection zone to exclude specific areas.
Adjusting sensor sensitivity to environmental factors like rain, snow, and fog.
Defining the minimum size of objects to be detected by the sensor.
Configuring the time delay before the sensor outputs are triggered.
Adjusting the direction or orientation of the detection field.
Setting the behavior of the sensor's relay outputs (NO/NC).
Configuring virtual push buttons for manual door activation and setting detection zones.
Setting up a secondary detection field to enhance safety during door opening operations.
Unlocking, adjusting parameters, and ending an adjustment session with the remote control.
Checking values, restoring factory settings, and managing access codes via remote.
Diagnosing issues related to no power, inverted polarity, or inactive LEDs.
Resolving problems with detection LEDs, masked sensors, or incorrect field detection.
Troubleshooting sensor non-responsiveness, access code issues, and remote control pointing.
To Next Page
General