7
Pair the Motor to the Remote
Set Limits
1. Press the PROGRAM button on the MOTOR for 2 seconds, the motor will beep and jog,
entering into pairing mode for 10 seconds.
2. Press the PROGRAM button on the REMOTE once, the MOTOR will beep.
3. Press the PROGRAM button on the REMOTE once again, the MOTOR will beep again.
4. Press the UP button on the REMOTE once, the MOTOR will beep 4 times and jog.
1. Press the PROGRAM button on the REMOTE once, motor will beep.
2. Press the UP button once, the motor will beep.
3. Press the PROGRAM button on the REMOTE once again, the motor will beep 3 times and jog.
4. Go to the top limit point and set it by pressing & holding STOP for 5 seconds until the motor
responds with a jog.
5. Go to the bottom limit point and set it by pressing & holding STOP for 5 seconds until the
motor responds with a jog.
Alternate Programming
If you encounter diculties with the steps under the Quick Start guide, try these alternate methods:
New, unprogrammed wireless wall switches come from the factory in LM (FM) mode. To make it
operate in FT (AM) mode:
Switch Transmitter Frequency — AM/FM (or Switch between the FL & ML Modes)
1. Determine the frequency. Press P2 once. The REMOTE will respond by emitting a blue
light at the front:
3 quick blue flashes = ML Motor (FM)
1 solid blue flash = FT Motor (AM)
2. Remove the battery in the REMOTE.
3. Press and hold the P2 button with the battery out.
4. Replace/insert the battery and release the P2 button.
Reset to Factory Defaults
Press & hold the PROGRAM button on the MOTOR, releasing after 3 jogs (6-8 seconds).
1st motor jog at the 2-4 second mark— keep holding;
2nd motor jog at the 4-6 second mark— keep holding;
3rd motor jog at the 6-8 second mark— release the PROGRAM button.
The MOTOR will beep 3 times to confirm the change.
To Previous Page
Loading...