Fac F 195 - Page 33

30
EN
“EXTRA CE” version
• The product tray (8) can be easily
removed by unscrewing the
corresponding support (7) placed under
it and by moving everything outward.
This way, a perfect cleaning of this
particular can be possible too.
For the machine’s body and blade cleaning use only a cloth
dampened in water or alcohol and a biodegradable frothy
dishwasher cleanser at pH 7-8, at a temperature at least of
+30°C.
Do not clean the machine with water or vapour jets or similar
methods.
Do not use alcohol based aggressive cleansers.
Do not use corrosive cleansers.
Do not wash in the dishwasher.
“CE HOUSEHOLD USE” version
• The machines are equipped with a
irremovable cap nut, as requested by
the European standard.
For this reason, it is not possible to
manually disassemble the product tray
(8).
6 .2 - Base cleaning
After removing the components like it’s
described in the previous pages:
• Clean all the disassembled parts and
the machine body using exclusively
hot water (at a temperature of at
least 30°C) and a biodegradable
frothy dishwasher cleanser (at pH
7-8).
• Use a soft, spongy cloth and,
possibly, a nylon brush for the tray
(8) and the product grip (10) sharp
zones.
• Rinse exclusively with hot water and
dry with soft and spongy cloths.
31
EN
6 .3 - Cleaning the blade
• Press on the blade with a wet cloth
(11) slowly rubbing moving from the
inside to the outside (towards the
gauge plate “17”).
ALWAYS perform the
blade cleaning (11)
when the gauge plate
(17) is close to the blade
in safety position.
6 .4 - Reassembling the machine
• Proceed in the opposite direction
to what is indicated in the previous
operations.
• To cover the slicer with a sheet to
protect it from dust is advised.
If you do not intend to use the slicer
for some days, store it in a dry and
covered place.
Fig. 8
11
17