Fac F 195 - Page 36

35
EN
• The lower wheel (x1) will have to remain inserted for almost half of its diameter between
the blade, on which it will lean, and the regulator plane.
• Insert the plug in the power socket and start the blade (with the appropriate command)
while keeping the product tray (8) (and the sharpener) still through the handle (15).
• Let the blade rotate for about 30÷40 seconds.
• Stop the blade movement by pressing the red button “0” (4).
• Check, with a slight shift (using a pencil) to the outside of the blade, if some burr has
formed.
We recommend to perform this checking very carefully as it
is a very sharp body.
• Ascertained the formation of burr, restart the blade and keep the wheel (x) button
pressed for 3/4 seconds.
Fig. 10b
3÷4 sec.
3a
4
15
x
x1
34
EN
• Remove the sharpener from the supplied bag.
• Unscrew the knurled knob (23) and insert the threaded metallic pin in the hole (y)
(specifically prepared on the product tray “8”).
•
Make sure that the two emery-wheels (x - x1) are pointed towards the blade to be sharpened,
easing the operation by pressing on the lower wheel “x1” button with your finger.
8
8
23
y
x
x1
x
x
x1
x1
Fig. 10a