Facom 779.CL2 - Product Specifications and Operation; Product Specifications; Lamp Operation Guide; Maintenance and Care

EN
SPECIFICATIONS
Weight
Luminosity
In-charge power input
Voltage
Protection rating
Storage temperature
Operating temperature
Battery
779.CL21
480 g
1000 Lux à 0,5 meter
14 W
7,2 V ----
IP 64 IK 9
-20°C ➙ + 70°C
-10°C ➙ + 50°C
Ni-MH pack batteries 1000 mAh min
779.CL12 Charger 100-230 V 50 - 60Hz - 12 VA double insulation output
Protection rating IP 20
Charging time 1,5 hours
Autonomy 6 hours (new LEDs and batteries)
Charging temperature 5°C ➜ + 45°C
Ni-MH batteries are consumables not covered by the guarantee.
The lamp’s autonomy is specified for new batteries.
OPERATION
- Before first use, charge the 779.CL2 inspection lamp for 3 hours.
The maximum autonomy is reached after 3 complete charge-discharge cycles.
- Power indicator on the base: green LED On.
The LEDs on the lamp blink to indicate charging. Once charging is complete, the LEDs are switched off.
- When switched on, the lamp’s intensity increases gradually to preserve LED lifetime.
- The lamp’s light intensity rises gradually when it is turned on to preserve the lifetime of the LEDs.
- When the operating time left drops to 1/4 hour, the lamp switches off and switches on instantly every 15 seconds.
- Batteries are sensitive to temperature: autonomy variations can occur at low temperatures
- The charging system is fitted with an automatic thermal circuit breaker.
- The 779.CL2 inspection lamp resists to most products and solvents used in automotive
repair and industrial shops (white spirit, petrol, diesel fuel, brake fluid, engine oil).
MAINTENANCE
- Never immerse the 779.CL2 inspection lamp in a cleaning product.
- Use a dry cloth with soapy water to clean your 779.CL2 inspection lamp.
- Use only FACOM spare battery packs, reference 779.CL16.
- Using non-compliant packs or improper usage can cause leaks or an explosion which would damage the lamp.
- Use only the 779.CL13 mains adapter supplied by FACOM. Using other mains adapters can cause
electrical hazard and start a fire.
- Before any prolonged use of the lamp, perform a full discharge-recharge cycle.
+
779.CL2
+
☞
250 mm
45mm
55 mm
779.CL16
779.CL21
779.CL12
779.CL13
+
+
779.CL16
Ni-MH
➡
779.CL14
OPTION
12 V / 24 V
EC statement of compliance:
WE, FACOM S.A., 6/8 RUE GUSTAVE EIFFEL - BP 99 - 91 423 MORANGIS CEDEX FRANCE, STATE UNDER OUR LIABILITY THAT THE FOLLOWING PRODUCTS:
779.CL2 – CORDLESS INSPECTION LAMP by FACOM
COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING EUROPEAN DIRECTIVES:
- ‘’LOW VOLTAGE’’ DIRECTIVE 73/23/CEE AMENDED BY DIRECTIVE 93/68/CEE
- ‘’EMC’’ DIRECTIVE 89/336/CEE AMENDED BY DIRECTIVE 93/68/CEE
AND COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING HARMONISED EUROPEAN STANDARDS:
- EN 55015 - EN 55022 - EN 55024
- EN 60598-1 - EN 60598-2-8 - EN 61000-3-2 - EN 61000-3-3 - EN 61547
30.11.04
Quality Manager
04