What to do if Facom DL.1GP Construction Equipment will not lift load?
If your Facom Construction Equipment won't lift a load, it might be due to an air block. To fix this, open the release valve and remove the oil filler plug. Then, pump the handle a couple of full strokes before closing the release valve.
Why Facom DL.1GP Construction Equipment pump feels unsteady under load?
If the pump on your Facom Construction Equipment feels unsteady under load, it could be that the pump cup seal is worn out. The suggested solution is to replace the cup seal with a new one.
What to do if Facom Construction Equipment will not lift to its full height?
If your Facom Construction Equipment pump won't lift to its full height, it may be because the reservoir is overfilled, or the hydraulic oil level is low. Check the oil level by removing the filler plug and top up the oil to the correct level.
What to do if Facom DL.1GP Construction Equipment will not lower completely?
If your Facom Construction Equipment will not lower completely, it could be due to an air block or the unit requiring lubrication. To resolve this, release air from the hydraulic pump by removing the filler plug and oil the external moving parts.
General| Accuracy | ± 1.5 mm |
|---|---|
| Display | LCD |
| Battery Type | 2 x AAA |
| Operating Temperature | 0°C to 40°C |
| Type | Laser |
| Resolution | 1 mm |
| Battery Life | 5000 measurements |
To Next Page