To Next PageTo Next Page
Need help?Do you have a question about the Fafner TD600 and is the answer not in the manual?
Explains the unit's effect loop for external units.
Details the tube section and its compensation.
Describes the full-range output for multiple poweramps.
Explains the low impedance output for driving tuners.
Details the internal accelerated MOSFET poweramp.
Covers power requirements, mains protection, dimensions, weight.
Details input impedance, level, and phantom power.
Covers gain range, peak LED, and frequency response.
Details compression ratio, attack, release, and distortion.
Describes LO and HI filter types and gain.
Details Bass, Middle, Treble, and Bright filter characteristics.
Explains the VOLUME knob's control over all unit volume.
Explains the STANDBY switch's function to mute outputs.
Describes the high-quality, electronically floating balanced output.
Details the effect loop for connecting external units.
Explains the DRIVE knob's gain control and overdrive.
Details the CHARACTER switch for two overdrive types.
Provides advice on tube replacement and safety.
Explains the LO filter's boost around 50 Hz for low bass.
Explains the HI filter's boost around 8 kHz for treble.
Shows frequency response curve for the Bass filter.
Shows frequency response curve for the Middle filter.
Shows frequency response curve for the Treble filter.
Explains the advanced high pass filter.
Explains the shelving type bass filter.
Explains the middle filter's frequency range.
Explains the treble filter's peaking frequency.
Explains the low noise, high impedance instrument input.
Details gain control for adjusting instrument signal strength.
General