17
6.9 Start-up setting
09P is the start-up setting. The display can choose the following start modes: 00→zero
start, 01→non-zero start.
Press i button to enter the parameter changing state. Press the plus/minus button to select
the parameter and press i button to save the parameter setting and return to the
personalized parameter setting interface.
Figure 6-9 Start-up setting interface
Figure 6-10 Ride mode setting interface
6.10 Ride mode setting
10P is the ride mode setting. The available ride modes are: 00→Pedal assist only, 01→
Electric only, 02→Both Pedal assist and electric.
Press i button to enter the parameter changing state. Press the plus/minus button to select
the parameter and press i button to save the parameter setting and return to the
personalized parameter setting interface.
To Next Page
Loading...
