FAFREES FF20 Polar - Page 21

18
6.11 Pedal assist sensitivity setting
11P is the pedal assist sensitivity setting. When set to higher numbers, it will take more
crank rotations to activate the motor. On lower numbers, it will take little crank rotation to
activate the motor. The adjustable range is: 1~24.
Press i button to enter the parameter changing state. Press the plus/minus button to select
the parameter and press i button to save the parameter setting and return to the
personalized parameter setting interface.
Figure 6-11 Pedal assist sensitivity setting interface
Figure 6-12 Pedal assist intensity setting interface
6.12 Pedal assist strength setting
12P is the pedal assist strength setting. The pedal assist strength is the relative strength of
the PWM signal from the controller when start to activate pedal assist. The adjustable range
is 0 ~ 5. 0 is the weakest strength and 5 is the strongest.
Press i button to enter the parameter changing state. Press the plus / minus button to select
the parameter and press i button to save the parameter setting and return to the
personalized parameter setting interface.