Under vacation, it is 14
O
C in the refrigerator and the temperatures in this chamber
cannot be changed.
1) To enter vacation
Click “option” until it ickers in “fast freezing” and then click “OK” to enter this func-
tion.
2) To quite vacation
Under vacation, click “option” until it goes to “vacation” and then click “OK” to quit
this function.
The light in vacation goes o and the refrigerator temperature goes back to the
value before vacation.
Vacation quits under functions of SmartECO and fast cooling.
With this design, the refrigerator can automatically keep all the setting in case of
power o. When the unit is plugged in again, the refrigerator will run with the setting
before power o.
To prevent harm to the refrigerator in case of sudden power cut and power on, the
unit does not start immediately if the power o time is less than 5 minutes.
When the freezer temperature is higher than 10
O
C at the rst time connected to
power, the symbol light of the freezer chamber goes on and the number represent-
ing temperature ickers.
Press any button or wait for 5 seconds, ickering stops and it goes back to the
temperature that was set.
When the refrigerator is open over 3 minutes, the buzzer will buzz. Close the door
or press any button to stop the alarm, but for the latter, the alarm will go o again
after 3 minutes.
Sensor fault alarm
When it shows “E0”, “E1”, “E2” or other abnormal symbols, it means sensor faults
and the refrigerator needs repair.
To Next Page
Loading...
