14
I. To switch on the scales, press
■
.
When the number beside the icon
begins to flash, you can select the
desired memory setting by moving up
and down with the
▲
and
▼
buttons.
Then press
■
to confirm the data.
II. The next parameter to be entered is
sex (male or female). When the symbol
starts to flash, use the
▲
and
▼
buttons
to choose male or female, then press
■
to confirm.
III. Another number will then begin to flash,
indicating the person’s
height. Use the
▲
and
▼
buttons to select the height
and press
■
to confirm.
IV. The last data item is age. Enter your
age using the
▲
and
▼
buttons and
press
■
to confirm.
To make sure all the parameters have been
correctly programmed, press the
■
button
consecutively when you finish programming.
BODY FAT MONITORING
When you wish to weigh yourself:
5. SCREEN DISPLAY (FIG. 2)
a. Male
b. Female
c. Memory
d. Height
e. Age
f. Unit of weight
g. % Body water
h. Status line
i. % Body fat
Insert a 9V battery in the battery
compartment (8) at the rear of the scales,
ensuring the polarity is as shown. Use
ALKALINE batteries only.
If the scales are to be out of use for some
time, remove the batteries.
Place the scales on a hard, flat surface (do
not place them on a carpet). To guarantee
maximum accuracy and repeatability of the
readings, always weigh yourself on the
scales in the same place.
PROGRAMMING
As we have already mentioned, the scales
have a programme for measuring the body
fat and body water percentage. Personal
data can be entered for each digit (from 1 to
8), i.e. for up to 8 different people. To
programme the scales, proceed as follows:
NOTE: first read the instructions, as the
display will switch off after 10 seconds if it is
not changed.
To Next Page
Loading...