42
Installation Instructions
2. TURN THE WATER ON AND PLUG IN
THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against
the back of the refrigerator or against the wall. Push the re-
frigerator back to the wall.
3. START THE ICEMAKER
Set the icemaker power switch to the l position. The ice-
maker will not begin to operate until it reaches its operating
temperature of –9°C or below. It will then begin operation
automatically if the icemaker power switch is in the l posi-
tion.
NOTE: In lower water pressure conditions, the water valve
may turn on up to 3 times to deliver enough water to the
icemaker.
To Next Page
Loading...
