EN
Page 37 of 43
4 CONFIGURATION
4.1 Programme management
If the washing machine is configured in self-service mode, only the first 16 programmes will be
available, the remaining programmes become available on entering Credit Mode.
4.2 Configure System
4.2.1 Advanced configuration
Credit Mode: If the washing machine is in self-service mode, the password for Credit Mode
(1234 by default) can be configured. Make a note of the password in a safe place. If you lose it,
please contact the technical support service.
HUD: In self-service mode, it is also possible to configure the Main screen (first and second
selection screens) and the Run screen. (See section 2.).
Beep: Option permitting the buzzer to be disabled. By default it is enabled.
RABC/Traceability: See advanced OPL configuration. In self-service mode, this should function
in the same way.
Grace Period: When this button is pressed, an intermediate screen is displayed from where it is
possible to activate or deactivate the grace period and edit the value between 1 and 99 minutes (the
default setting is enabled and 1 minute).
Self-service statistics: This provides data about payments and the number of times each of the
favourite programmes is run.
When the self-service statistics button is pressed, the following screen is displayed.
Press “TOTAL” to display the total values for the machine. If a date is entered, the statistics are only
shown for this period. Press “Reset” to set all the values to 0, resetting the statistics.
Currency: Select currency with which you wish to operate (see section 4.2.3.). If the currency is
changed, all the prices will be reset, by default to token.
To Next Page
Loading...
