Fairford XFE Series - Semiconductor Fuse Types; Short Circuit Co-ordination; EMC Emission and Immunity Levels

10 M-85E0-F O81121
Short circuit
co-ordination Type 1
Special purpose fuses, for the protection of semi-conductor devices, rated 700 Vac, can be used to obtain the
required short circuit ratings. Suitable for use on a circuit capable of delivering not more than the RMS Symmetrical
Amperes indicated in this table at maximum rated operational voltage, when protected by Semiconductor Fuse
type, Manufactured by Company and Mod. No. indicated.
These fuses are for short circuit protection of the semiconductors and must be mounted externally by the user
between the unit and the mains supply, not between the unit and the motor.
5 63
5 63
5 63
5 63
5 80
5 80
5 80
5 100
5 100
5 100
10 250
10 250
10 250
10 250
10 250
10 400
10 400
10 400
10 450
18 500
SIBA Fuse
Amps
Short
circuit
Amp
RMS
(kA)
2018920.63
2018920.80
2018920.100
2061032.250
2061032.400
2061032.450
2061032.500
2018920.63
2018920.63
2018920.63
2018920.80
2018920.80
2018920.100
2018920.100
2061032.250
2061032.250
2061032.250
2061032.250
2061032.400
2061032.400
18 630
18 630
18 630
18 800
18 800
30 900
30 2068132.800 800
30 2067132.1000 1000
42 2067132.1000 1000
42 2068132.1250 1250
85 2068132.1400 1400
85 2068132.1400 1400
85 2068132.1400 1400
85 2068132.1400 1400
85 2 x 2067132.1000 2000
85 2 x 2067132.1250 2500
100 2 x 2067132.2000 4000
100 2 x 2067132.2000 4000
Short
circuit
Amp
RMS
(kA)
SIBA Fuse
Amps
2068132.1400
85
2068132.1250
42
1250
1400
2061032.630
2063032.630
2063032.800
2063032.900
2061032.630
2063032.800
XFE
No.
XFE
No.
Document No TF0120 ‘Guide to Soft Start Drive Product Information’, describes the rating index and the meaning
of other IEC 60947-4-2 product information in more detail. This is available upon request from Fairford.
Basic standard Level
IMMUNITY
IEC 61000-4-2 6kV contact or 8kV air discharge
Severity level 3
IEC 61000-4-6 140dBuV over 0.15-80MHz
IEC 61000-4-3 10V/m over 80 -1000MHz
IEC 61000-4-4 2kV/5kHz
IEC 61000-4-5 2kV line to ground and 1kV line to line
EMISSION
EN 55011 Class A
Equipment Class A (Industrial)
EMC Emission and Immunity levels
EMC compliance is in accordance with EN 60947-4-2 which refers to the following basic standards:
Note: EN 60947-4-2 is published as a harmonized standard under European Council Directive No.89/336/EEC
in relation to the electromagnetic compatability.
Semiconductor Fuse types
XFE202
XFE204
XFE206
XFE208
XFE210
XFE212
XFE302
XFE304
XFE306
XFE308
XFE310
XFE312
XFE314
XFE316
XFE318
XFE319
XFE320
XFE322
XFE324
XFE326
XFE102
XFE104
XFE106
XFE108
XFE110
XFE112
XFE114
XFE116
XFE118
XFE120
XFE122
XFE124
XFE126
XFE128
XFE130
XFE132
XFE134
XFE136
XFE138
XFE140