To Next PageTo Next PageWhat to do if the LED of the start button is continuously flashing with a beep sound on my Fakir Cleaning Equipment?
This issue occurs when less than 400 ml of water and 0.5 g of salt have been added. For safety reasons, the appliance will not operate if the amount of water is insufficient or too much salt is added. Add the recommended amount of salt and water, then run the appliance again.
Why is the LED still on even after the cleaning process is complete on my Fakir Cleaning Equipment?
It is normal for the LED light on the bottom of the Spray Bottle and the LED for the Start Button to remain lit after the water production is complete, indicating that the process is finished. To turn off the LED light in the bottle, remove the Spray Bottle from the Body. Note that this does not turn off the LED light in the Body.
What to do if the LED is on but bubbling on my Fakir Cleaning Equipment?
This happens when the Spray Bottle is not properly installed in the body. Ensure the Sprayer Bottle is correctly placed in the Body to resolve this issue and check that the appliance is working.
What to do if my Fakir Cleaning Equipment does not operate after the cleaning water production process is completed?
It is normal for the appliance not to operate for 1 minute after electrolyzed water is produced. Please wait for one minute after the previous process.
Why is my Fakir Cleaning Equipment slightly bubbling?
Slight bubbling can occur if pure water or mineral water is used instead of tap water. Use only tap water. Also, using salt will cause more bubbles compared to using only tap water.
How to fix the LED not lit issue in Fakir Cleaning Equipment?
The adapter or plug may not be properly connected. Ensure that the adapter and the outlet are properly connected.
General| Brand | Fakir |
|---|---|
| Model | HYPO CLEAN |
| Category | Water System |
| Language | English |
