9
How To Recharge Your Vacuum
Cleaner
CAUTION: Re-charge your unit only
with provided charging adaptor
1. Hold bracket against wall to mark
location for screws. Make sure the
wall bracket is positioned vertically,
with the charger socket at the top.
2. Use a 6 mm drill for drilling holes for
the plastic anchors.
3. Ins et t he anch ors a nd d r iv e t he
screws into both holes, leaving 6 mm
of each screw exposed.
4. Place the bracket over the screws
and slide the bracket downward to
allow the screws t
o move into the
slots.
5. Tight en the screws to secure the
bracket.
6. Plug the charger into an electrical
outlet.
7. Rest the cleaner on the doc king
ledge, with the nozzle pointed down,
and push in on the top of the handle
until you hear charger socket click
into place. The charging indicator
light on the vacuum will illuminate to
indicate that the vacuum cleaner is
properly charging.
NOTE: CHARGE THE CLEANER FOR
10-12 HOURS BEFORE INITIAL USE.
TH
E BATTERIES OF A NEW CLEANER
ARE ON A LOW CHARGE.
Keeping Your Vacuum Cleaner Ready
For Use
Return your vacuum cleaner to the
recharging stand after every use. Firmly
position into the recharging stand ensuring
that the vacuum cleaner fits correctly onto
the contacts.
It will then be recharged and ready for
operation at all times.
The plug charger can be left in the electrical
outlet at all times. It is impossible to
overcharge the batteries. The plug charger
will become warm, however, this is not a
cause for concern.
To Next Page
Loading...
