Selecting the temperature.
• Put the iron in a vertical position.
• Put the plug in the socket.
• Adjust the thermostat knob according to
the international symbol on the garment
label.
The power indication light indicates that
the iron is heating up. Wait until the power
indication light goes off before ironing.
Warning: During ironing, the power
indication light comes on at intervals,
indicating that the selected temperature is
maintained. If you lower the thermostat
temperature after ironing at a high
temperature, do not start ironing until the
power indication light comes on again.
Selecting the steam
The quantity of steam is regulated by the
steam selector.
• Move the steam selector to a position
between minimum and maximum
depending on the quantity of steam required
and the temperature selected.
Warning: The iron gives off steam
continuously only if you hold the iron
horizontally. You can stop the continuous
steam by placing the iron in a vertical
position or by moving the steam selector
to “ ”. As indicated on the thermostat knob
and in the initial table, you can only use
steam at the highest temperatures. If the
selected temperature is too low, water may
drip onto the plate.
Selecting Shot-steam and steam when
ironing vertically.
Press the shot-steam button to generate a
powerful burst of steam that can penetrate
the fabrics and smooth the most difficult
and tough creases. Wait for a few seconds
before pressing again.
By pressing the shot-steam button at
intervals you can also iron vertically
(curtains, hung garments, etc.)
Warning: The shot-steam function can only
be used at high temperatures. Stop the
emission when the power indication light
comes on, than start ironing again only after
the light has gone off.
DRY IRONING
To iron without steam, follow the instructions
in section “steam ironing”, leaving the steam
selector on position “ ”.
Spray Function
Make sure that there is water in the reservoir.
Press the spray button slowly (for a dense
spray) or quickly (for a vaporized spray)
Warning: For delicate fabrics, we
recommend moistening the fabric
beforehand using the spray function, or
07
To Next Page
Loading...
