9Vehicle
Figure 1
Adjusting the steering slider
FALLER Car System vehicles can only be steered
optimally if the slider is adjusted correctly. The
slider is adjusted correctly at the factory. Howev-
er, deviations may occur during vehicle operation.
It will then need to be readjusted. The magnetic
slider should always glide parallel to the road
surface. Please refer to figure 2 for the ideal set-
ting. On small vehicles with folded slider tip the
magnetic force can be adjusted by bending it
with the tip of a knife. This may be required to
optimise the steering thrust, for example if the
steering stops due to the magnet being posi-
tioned too high or the slider »sticking« to the
road due to the magnet being too close.
Figure 2
Please note:
• The magnet must rest on the road.
• The screw connection on the slider must
show some play.
Changing tyres
Even model cars require maintenance. Routine
tyre changes are required based on the mileage.
Insufficient tread results in a loss of traction and
steering issues. This will be noticeable in curves
and on hills. Routinely checking tyres is there-
fore advisable.
By the way: changing tyres is even easier and
faster than in real life.
You may purchase spare tyres and all other spare
parts through FALLER’s customer service. Be sure
to also include the vehicle’s item number when
ordering.
Customer Service
If you’re ever stuck or you’re missing a part, in
addition to skilled advise at your local retail store
you may also contact our customer service. We
will help you quickly and find an unbureaucratic
solution for virtually any case. Your direct line to
our customer service: + 49 (0) 7723 651-106
or e-mail us at kundendienst@faller.de
To Next Page
Loading...
Need help?
General
