To Next PageTo Next Page
Need help?Do you have a question about the Falltech 7324 and is the answer not in the manual?
General| Product Type | Full Body Harness |
|---|---|
| Material | Polyester |
| D-Ring Locations | Back |
| D-Rings | 1 |
| Adjustable Leg Straps | Yes |
| Adjustable Shoulder Straps | Yes |
| Weight Capacity | Up to 310 lbs (140 kg) |
| Standards | ANSI Z359.11-2014 |
Details the intended use of FallTech Pass-Through Anchors in various safety systems for worker protection.
Explains the components of a Personal Fall Arrest System (PFAS) including harness and connecting device.
Discusses system performance variations and factors like freefall, clearance, and impact forces.
Lists specific applications where FallTech Pass-Through Anchors are suitable, including arrest, restraint, and positioning.
Specifies the single-user capacity and connection limits for Pass-Through Anchors.
Defines criteria for compatible connectors to prevent inadvertent gate opening and ensure safety.
Instructs on using only self-locking connectors and ensuring proper connection and locking.
Details PFAS requirements, including harness use and arresting force limits.
Outlines anchorage strength requirements for PFAS, specifying load capacity and certification absence.
Guides hazard assessment and planning for a PFAS, covering anchorage and work zones.
Provides instructions for selecting a suitable anchor point and ensuring secure connector usage.
Explains the concept of MRFC and the variables influencing fall clearance needs.
Describes the phenomenon of swing falls and the forces generated, highlighting potential injury risks.
Details pre-use inspection steps for the anchor, checking for damage and stitch integrity.
Step-by-step guide for installing the Pass-Through Sling Anchor on a structural member.
Instructions for installing the Cable Pass-Through Sling Anchor on a structural member.
Provides instructions for installing the Choke-On Sling Anchor on a structural member.
Details the installation process for the Cable Carabiner Sling Anchor on a structural member.
Guidelines for cleaning the anchor with water and mild detergent, avoiding harsh chemicals.
Recommendations for keeping the anchor clean, dry, and free of contaminants to ensure longevity.
Instructions for storing the anchor in a clean, dry, and chemical-free environment out of direct sunlight.
References the pre-use inspection guidelines detailed in Section 5.4 for required checks.
Outlines recommended inspection frequencies based on the type of use and conditions.
Specifies actions to take if inspection reveals defects, damage, or inadequate maintenance.
Details the requirement to record inspection results on an inspection record document.
