5
Periphal Connections/Preamp of the ML-30R
Signal In Jacks
The ML-30R has two mono style 1/4” input jacks
for the connection of your electric guitar. They are
named with “High” and “Low” and will transmit the
output level of your guitar to the preamp of the am-
plifi er. When using an instrument with a high output
(i.e. built-in humbuckers), you should use the “Low”
input for best performance. An electric guitar with
low output should be connected to the “High” input.
Headphones
For quiet practicing at home you can also use
optional headphones. For best performance and a
brilliant sound, we recommend our Fame DT 290
studio headphones. Please note that the overall
volume of the amplifi er will infl uence the master
volume of your headphones.
CONNECTIONS ON THE BACK
Mains
This jack is used to connect the ML-30R to a grounded
power outlet.
PREAMP SECTION OF THE ML-30R
Clean
When the “Overdrive“ switch of the ML-30R is
inactive (not pushed in), the amplifi er works in the
“Clean“ mode. The Volume/CH1 knob controls the
overall volume of the ML-30R.
Overdrive
The “Overdrive“ mode produces a distorted lead
sound. The gain knob controls the amount of
distortion, while the Volume/CH2 knob controls the
overall volume of the channel.
Reverb
The ML-30R features a reverb function, where small
and big rooms will be simulated. You should be
careful when using this effect, because it can also
change the sound to something intransparent.
Your guitar cord is an important part of your signal chain and it‘s quality and
construction type clearly affects the overall tone of your rig. Try and buy the
best quality cord you can or want to afford for maximum sound!
To Next Page
Loading...
