What to do if the pulse ox sensor is off the patient when using F&P Medical Equipment?
Check that the sensor is properly attached to a suitable measurement site on the patient when using F&P Medical Equipment.
What to do if the F&P Medical Equipment detects a blockage?
If the Airvo 3 Medical Equipment detects a blockage, check the heated breathing tube, patient interface, and inlet air filter for obstructions. Also, ensure the patient interface is the correct size and the target flow rate is within range. If problems persist, replace the consumables.
How to fix a device fault on F&P Medical Equipment?
To resolve a device fault with your F&P Medical Equipment, restart the device. If the issue persists after restarting, contact your service representative.
What to do if F&P Medical Equipment shows 'Check Tube'?
If the Airvo 3 Medical Equipment cannot detect the heated breathing tube, check that the tube is not damaged and is plugged in correctly. If the problem continues, replace the heated breathing tube.
What to do if disinfection failed to hold temperature on F&P Medical Equipment?
Check that the disinfection tube blue connector is connected to the top of the outlet elbow, the disinfection tube red end is connected to the left hand chamber port, the disinfection filter is connected to the right hand chamber port. Then restart the device. If the problem is not resolved, replace the disinfection tube and outlet elbow in turn on your F&P Airvo 3 Medical Equipment.
What to do if wall power is disconnected during disinfection on F&P Medical Equipment?
Connect device to wall power, then restart the device on your F&P Airvo 3 Medical Equipment.
What to do if F&P Airvo 3 Medical Equipment indicates 'Critically Low Battery'?
If the Airvo 3 Medical Equipment indicates a critically low battery, connect it to a wall power supply immediately to maintain therapy. Humidification is turned off to maintain operation of the blower and oxygen supply.
What to do if there's no O2 pressure at the HPO port on F&P Medical Equipment?
If there is no oxygen being supplied to the high-pressure (HPO) inlet port during therapy with your F&P Airvo 3 Medical Equipment, check that the oxygen supply is working. If using an oxygen bottle, check the bottle is not empty. If switching to the low-pressure (LPO) inlet port or stopping oxygen delivery, set the FiO2 target to 21 %.
What to do if the 'Outlet Elbow' is too warm on F&P Medical Equipment?
If the outlet elbow is too warm to run startup checks on your F&P Airvo 3 Medical Equipment, wait for the outlet elbow to cool down. If the issue persists, replace the outlet elbow.
Why is the flow above target on F&P Medical Equipment?
If the Airvo 3 Medical Equipment flow rate is higher than the target, check for leaks in the water chamber, heated breathing tube, and patient interface. Ensure the inlet air filter is correctly inserted and the target flow rate is within range. If the issue persists, replace the consumables.
Information on where to find more help and resources for using the Airvo 3 device.
Explains the meaning of warning, caution, and note symbols used throughout the manual.
Overview of the Airvo 3, its intended use, indications, contraindications, and side-effects.
Covers general warnings, oxygen safety, and pulse oximetry safety precautions.
Identifies system and device components, and explains user interface navigation.
Steps for setting up the device, equipment, and oxygen connections.
Details on therapy settings, starting, and managing operation.
Accessing and interpreting patient data, live values, and long-term graphs.
Guidance on resolving common alarms, faults, and device problems.
Instructions for cleaning and disinfecting the Airvo 3 and its accessories.
Connecting, configuring, and using pulse oximetry for patient monitoring.
Provides detailed technical data for the Airvo 3 device and its operations.
General| Brand | F&P |
|---|---|
| Model | Airvo 3 |
| Category | Medical Equipment |
| Language | English |
To Next Page
