16
Note:
a) The self-timer mode remains activated as default. In order to switch to single snapshot mode,
please manually turn off self-timer mode.
b) The self-timer mode and continuous shooting mode cannot be activated at the same time.
3. Setting of system parameter:
a) Beep: Turn on or turn off the key tone.
b) Self lamp: Please turn it on or off The rec LED, the default setting is “ON”.
c) Loop coverage: The video/ audio file will be auto saved in segment once every 15 minutes when
setting “Loop Coverage”. If it is not set, the video/ audio file will be auto saved in segment once every
30 minutes.
Note:
The current actual segment file is determined by the file size set, but not determined by the true time,
that is to say, the file will be segmented more than 15/30 minutes at a dark environment.
d) Auto standby: Set the auto standby time to 0, 2 minutes, 5 minutes or 10 minutes. If there’s mission
or operation, the system will start the standby countdown and the device will turn off. If there is an
operation during the countdown, the system will restart it. If video recording or the shutter is operated
in the standby mode, the device will be waked up.
e) TV output format: NTSC or PAL video format output to TV. If the selected format is changed, please
unplug the AV cable and then reinsert it to update the parameters. This Function will accepted after a
Camera restart.
To Next Page
Loading...