EasyManua.ls Logo

Fantic FAT INTEGRA - 5. What to Do Following a Fall; 6. How to Transport Your Bicycle; 7. Locking;Releasing the Front Suspension Fork; 8. Front Suspension Fork Adjustment

Fantic FAT INTEGRA
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
05
Ed. 1 - 03/2019Ed. 1 - 03/2019
ENGLISH
EN_19
Using your bicycle
- To move forward, place your left foot on the
left hand pedal and your right foot on the right
hand pedal.
- This action may be performed either while sit-
ting on the saddle, or standing up in the ped-
als.
5. WHAT TO DO FOLLOWING A
FALL
-
In the event of a fall or an accident, contact your
vendor immediately in order carry out a thor-
ough check on your bicycle before reusing it.
- Do not attempt to ride your bicycle again until
it has been inspected by the vendor, and re-
paired if necessary.
Failure to replace such compo-
nents, if damaged, may result
in hazardous riding conditions,
falls, accidents and damage to
property.
Carefully read that stated in the
safety recommendation booklet.
6. HOW TO TRANSPORT YOUR
BICYCLE
- To transport the bicycle correctly (e.g. in the
car), the front and/or rear wheel may have to
be removed (see sections “03“ and “07“).
To transport the bicycle correctly
and carefully, read the specic
recommendations in paragraph
“1.f“ of the safety recommenda-
tions booklet.
7.
LOCKING/RELEASING THE
FRONT SUSPENSION FORK
- Under certain riding conditions it is possible to
block the front fork by turning the ring “1” as
shown in the picture. Each mark corresponds
to a dierent locking (g. “48“).
To unlock the fork turn the ring “1” in the oppo-
site direction.
8. FRONT SUSPENSION FORK
ADJUSTMENT
- To adapt the fork return speed (Rebound) to
the road type and to the user’s weight it is pos-
sible to intervene adjusting air pressure inside
the fork by working as follows (g. “49“):
hop on the bike and check how much the front
fork lowers; the correct quota is 10÷15% of the
total stroke.
If the fork lowers more, it is necessary to remove
the cap “2” and, using an appropriate not sup-
plied pump, blow air inside the fork (max 150
psi) (g. “50“).
If the fork lowers less, deate air by pressing the
pump button (g. “51“).
Adjust the fork return speed by operating on the
ring under the stem:
adjustment screw type A - (g. “52“)
adjustment screw type “B” - (g. “53“)
- Release both the brake levers.
- Start pedalling.
- ENJOY YOURSELF!
Do not leave the bicycle where it may be
exposed to direct sunlight: the battery pack
may over heat causing the safety device to
intervene.
For the “Living“ version only
The rack is not suitable for the
transport of persons and child
seats (g. “47”).

Related product manuals