FANUC 0i-tc - 10 CREATING PROGRAMS

OPERATION10. CREATING PROGRAMS
B–64114EN/01
570
10
CREATING PROGRAMS
Programs can be created using any of the following methods:
⋅
MDI keyboard
⋅ PROGRAMMING IN TEACH IN MODE
⋅ CONVERSATIONAL PROGRAMMING WITH
GRAPHIC FUNCTION
⋅ MANUAL GUID 0i
⋅ AUTOMATIC PROGRAM PREPARATION DEVICE (FANUC
SYSTEM P)
This chapter describes creating programs using the MDI panel, TEACH
IN mode, and conversational programming with graphic function. This
chapter also describes the automatic insertion of sequence numbers.