Far Tools P 13E - Settings of the Machine; Drawback Spring Adjustment

Settings of the machine
FIG. F
replacing consumables
-
01
FIG. G
Maintenance, recommendations and advice
EN
The use of suitable accessories in good condition will ensure the machine operates optimally
01
-
02
Spindle lubrication
02
To avoid rust, grease machined metal parts ( table, column, etc.)
03
Check the condition of the belts regularly
04
Belt tension
-
Setting the drawback spring
-
01
02
03
04
Lubricate the bit when drilling with a mixture of soluble oil and water
05
Adapt the rotation speed of the chuck to the diameter of the drill:
- Small diameter = high speed
- Large diameter = low speed
06
3000
2500
2000
1500
1000
500
0
5 10 15 20 25 30
2800 min
-1
= 3 mm
300 min
-1
= 30 mm
ø (mm)
111050-Manual-F.indd 17 12/05/15 15:45:04