FAR KJ 60 - User Manual

Other manuals for FAR KJ 60

Translation Of Original Instructions76 pages

Original Instructions For Use19 pages

Instructions For Use28 pages

Questions and Answers

R
Rose JonesAug 1, 2025
Why is my FAR Rivet Tool not fastening the rivet?
- S
  spencerchelseaAug 1, 2025
  Your FAR Rivet Tool might not be fastening rivets due to several reasons. If it's a non-powered tool, ensure it is connected to a compressed air source. Also, verify that the tie rod and rivet nut threads match correctly and are properly adhered. A lack of oil can also cause this issue, so top up the oil. Confirm that the correct tie rod is installed and that the air supply is filtered and lubricated, so equip yourself with a lubricator filter assembly.
D
Donald WardAug 6, 2025
What to do if my FAR Rivet Tool's pneumatic motor runs slowly?
- J
  Joshua TateAug 6, 2025
  If the pneumatic motor of your FAR Rivet Tool is running slowly, it could be due to a few reasons. Check for air leaks from the motor and replace any worn seals if necessary. Also, the air pressure might be too low, so try increasing it. Finally, check for any blockages in the airflow and remove them.
B
Brandon FowlerAug 10, 2025
Why is my FAR Rivet Tool leaking oil?
- R
  Robin MurphyAug 11, 2025
  Your FAR Rivet Tools could be leaking oil because the oil filler cap is not tightened correctly, so tighten correctly. If the gaskets are worn, contact the service center.
R
Robert SmithAug 16, 2025
Why is my FAR Rivet Tool leaking air?
- A
  Aaron CarsonAug 16, 2025
  If your FAR Rivet Tool is leaking air, ensure the feeding tube is positioned correctly. If the gaskets are worn or there are breaks on the riveting machine body, contact the service center.
T
Tami FowlerAug 20, 2025
What to do if the tie rod breaks on my FAR Rivet Tools?
- P
  Patrick LeeAug 21, 2025
  If the tie rod of your FAR Rivet Tool breaks, it could be due to excessive stroke or pressure, so decrease both. Additionally, ensure that there is no lateral load on the tie rod by keeping the tool in axis.
J
Joshua GibsonAug 26, 2025
What to do if the rivet nut does not correctly match the tie rod in my FAR Rivet Tools?
- A
  ann49Aug 26, 2025
  If the rivet nut doesn't correctly match the tie rod in your FAR Rivet Tool, it might be due to an incorrect thread pitch, so replace the tie rod and head. Alternatively, the tie rod might not be correctly installed, so ensure it is installed correctly. Finally, a worn or damaged tie rod can cause this issue, so replace the tie rod.