TROUBLESHOOTING
GB-27
If your appliance malfunctions, an information code may appear on the screen.
Check the table below and try the suggestions.
Code InformaƟon code AcƟon
The washer fills over time
Check if the tap is opened.
Check if the water pressure is too
low.Check if the inlet hose is blocked.
Water drainage over time
Check if the drain pump is blocked.
Contact a technician if necessary.
Door lock is breakdown
Close the door well again.
Check if the clothes is caught
between
the door and seal.
Contact a technician if necessary.
Water is overflowed Please contact a technician.
The electrical motor is
breakdown
Please contact a technician.
The heater does not work Please contact a technician.
There is a tempe
rature
sensor fault
Please contact a technician.
Unmatched software/
hardware on mainboard and
frequency inverting plate.
Please contact a technician.
communication failures Please contact a technician.
Inverter failures Please contact a technician.
The procedure running is not
corresponded to the cycle
that the knob points.
Turn the cycle selector to the cycle
corresponded to the procedure
working on.
If an information code remains displayed on the screen, contact a local
service center (Please refer to the “ CUSTOMER SERVICE” chapter).
ENGLISH
To Next Page
Loading...
