ENGLISH
GB-12
Please take the following steps to remove the
bolts:
1. Loosen 4 bolts with spanner and then
remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future
use.
Levelling the washing machine Warning!
Warning!
• e lock nuts on all four feet must be
screwed tightly against the housing.
1. Check if the legs are closely attached to the
cabinet. If not, please turn them to their
original positions tighten the nuts.
2. Loosen the lock nut turn the feet until it
closely contacts with the oor.
3. Adjust the legs and lock them with a spanner,
make sure the machine is steady.
Raise
Lower
Lock nut
foot
To Next Page
Loading...
