Farberware SM3481RBG - Stand Mixer Assembly

6 7
OPERATION
Assembly
WARNING:
- Always disconnect the plug (6) from the wall outlet before attaching or
removing accessories to/from the appliance. Allow moving parts of the
appliance to stop completely before handling.
- Incorrect assembly may lead to an unstable setup and might cause injuries.
• Place the appliance on a clean, flat and heat resistant surface.
• Lift the release lever (4) on the back of the appliance and then lift the head (2)
until it locks in place (ill.
a
).
• Insert the bowl (10) on the clamping plate (9) and turn clockwise to lock it in
place (ill.
b
).
• Insert the required attachment (12, 13, 14) onto the drive shaft (11). Push up and
turn it counterclockwise until it locks in place (ill.
c
).
• Lift the release lever (4) on the back of the appliance and then lower the head (2)
until it locks in place (ill.
d
). Ensure the attachment (12, 13, 14) does not touch
the bowl (10).
WARNING:
- Do not use the appliance if the attachment (12, 13, 14) touches the bowl (10).
Risk of injuries and damage to the appliance ( Troubleshooting).
- Do not use the appliance without the bowl (10) securely in place (ill.
e
).
- Never place the pouring chute on the opposite side of the speed control
knob (5).
• In case of liquid mixtures, slide the splashing guard (15) onto the bowl (10) with
the pouring chute on the side of the speed control knob (5) (ill.
f
). Ensure the
bottom rim of the splashing guard (15) sits properly in place onto the bowl (10).
NOTE:
- Do not use the appliance without any attachment (12, 13, 14) on the drive
shaft (11) (ill.
g
).
- Do not store the attachments (12, 13, 14) on the drive shaft (11).
- Never attempt to remove the bowl (10) from the clamping plate (9) during
operation.
• To disassemble, repeat previous steps in reverse order of assembly.
Stand Mixer_HA-3481RB_IM_US_V9_171220.indd 7 12/20/17 4:51 PM