Farberware SM3481RBG User Manual (English)

Questions and Answers:

M
Michael Robertson Jr.Aug 9, 2025
What to do if my Farberware SM3481RBG is not working?
- R
  rossjaredAug 9, 2025
  First, make sure the Farberware Mixer is properly plugged into a working wall outlet. Check your fuses and circuit breaker to ensure the outlet is energized. If the mixer still doesn't work, set the speed control knob to '0', unplug it, and let the motor cool down for at least 20 minutes before restarting. If it still fails, the appliance may be malfunctioning, in that case set the speed control knob to the '0' position, unplug the appliance and contact qualified personnel to check and repair it.
M
Melanie WeberAug 18, 2025
What to do if rotating attachment touches the bowl during operation of Farberware Mixer?
- R
  Rebecca ClayAug 18, 2025
  If the rotating attachment touches the bowl during operation of your Farberware Mixer, the drive shaft may be misaligned. Set the speed control knob to the '0' position, unplug the appliance from the wall outlet and contact qualified personnel to check and repair the appliance.
S
Scott MejiaAug 25, 2025
Why the head of my Farberware SM3481RBG Mixer cannot be fully pushed down?
- J
  Jordan BaileyAug 25, 2025
  If the head of your Farberware Mixer cannot be fully pushed down or won't lock, a foreign item might be blocking the head or base hinge. Remove any obstruction from the hinge. If the problem continues, stop using the appliance and contact qualified personnel to inspect and repair it.
S
Sabrina WestAug 31, 2025
Why is the drive shaft on my Farberware Mixer rotating slowly?
- N
  Nina PetersonSep 1, 2025
  If the drive shaft of your Farberware Mixer rotates very slowly or not at all, it could be due to too much food in the bowl or an overloaded motor. If there is too much food, remove the bowl, take out some of the ingredients, redistribute the remainder, and restart. If the motor is overloaded, turn and hold the speed control knob counterclockwise to the 'P' position for a few seconds and then release it. Repeat this until you achieve the desired result.