What to do if Farm King Farm Equipment augers won't start?
If the augers on your Farm King Farm Equipment won't start, there could be a couple of reasons. First, check for any obstructions or blockages in the auger. If you find something, shut off the tractor, disconnect the PTO, and then remove the obstruction. Another possibility is a bearing failure. Inspect the bearings and replace them if needed.
Why is the grain flow too slow in my Farm King Farm Equipment?
If the grain flow is too slow in your Farm King Farm Equipment, it might be because the discharge gates aren't open enough. Try opening the gates more to allow a faster grain flow to the hopper intake auger. Also, check the tractor RPM; if it's set too low, raise it to the proper setting.
How to decrease grain flow in Farm King Farm Equipment?
If the grain flow in your Farm King Farm Equipment is too fast, it's likely that the discharge gates are open too far. To fix this, close the gates a bit to reduce the grain flow to the hopper or intake auger.
What to do if lights don't function on Farm King Farm Equipment?
If the lights on your Farm King Farm Equipment aren't working, begin by checking the electrical connection at the tractor to ensure it's secure. If the connection is good, inspect the harness and wiring for any breaks. Finally, check the tractor light circuit to rule out any issues there.
To Next Page
General