Why is the grain flow too slow in my Farm King Tools?
If the grain flow is too slow in your Farm King Tools, first, ensure that the discharge gates are sufficiently open to allow a faster grain flow to the hopper intake auger. If the issue persists, check that the tractor RPM is set to the proper setting and raise it if it's too low.
How to troubleshoot augers that cannot start on Farm King Tools?
If your Farm King Tools augers won't start, the problem could be due to a plugged auger or an obstruction. To resolve this, shut off the tractor, disconnect the PTO, and then carefully remove the obstruction. Another potential cause is bearing failure, so inspect the bearings and replace them if necessary.
What to do if the grain flow is too fast in Farm King Tools?
If the grain flow is too fast in your Farm King Tools, it's likely that the discharge gates are open too far. Try closing the gates to reduce the grain flow to the hopper or intake auger.
To Next Page
General