Maintenance - Teleswing
43
LUBRICATION
Always use a good quality multi-purpose / lithium
base grease when lubricating the equipment.
• Always use a hand-held grease gun.
• Clean fitting before greasing, to avoid injecting dirt
and grit.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean
thoroughly. Replace fitting if necessary.
IMPORTANT
Fluid such as engine oil, hydraulic fluid,
coolants, grease, etc. must be disposed of
in an environmentally safe manner. Some
regulations require that certain spills and leaks
on the ground must be cleaned in a specific
manner. See local, state and federal regulations
for the correct disposal.
TIRE PRESSURE
CAUTION
When inflating tires, use a clip-on chuck and
extension hose long enough to allow you to
stand to one side and NOT in front of or over
the tire assembly.
Check tire pressure daily. Fill tires per tire
manufacturer’s recommendation. See side wall of
tire for inflation requirements.
WARNING
AVOID INJURY OR DEATH
Always chock tires before performing any
maintenance or service.
To Next Page
Loading...
