Assembly - Teleswing
23
COMPONENT UNLOADING AND
IDENTIFICATION
Unload the crate(s) and components in flat level
area of adequate size to assemble the auger.
DANGER
ELECTROCUTION HAZARD
To prevent serious injury or death from
electrocution:
• Be aware of overhead power lines.
• Keep away from power lines when unloading
and assembling the auger.
• Electrocution can occur without direct contact.
WARNING
DO NOT permit bystanders to be in the
work area when unloading and assembling
components.
DO NOT work under suspended parts.
Keep away from moving parts.
Always use lifting devices / vehicles, chains
or straps of adequate size and strength when
unloading and assembling components.
IMPORTANT
Unload crate(s) and auger components
carefully, not to cause damage to any of the
components.
Using the packing list, locate and place all
components and hardware in one area. Count
the individual components and verify that
you have received the correct number of
components to fully assemble the auger.
If any components are damaged, missing or
replacement parts are required, contact your
Farm King Dealer.
Figure 3
Larger components are marked (Item 1) [Figure 3]
for identification.
1
To Next Page
Loading...
