Maintenance - Teleswing
41
TROUBLESHOOTING
Chart
WARNING
Instructions are necessary before operating or servicing equipment. Read and understand the
Operator And Parts Manual and safety signs (decals) on equipment. Follow warnings and instructions
in the manuals when making repairs, adjustments or servicing. Check for correct function after
adjustments, repairs or service. Untrained operators and failure to follow instructions can cause
injury or death.
NOTE: If a problem is encountered that is difficult to solve, even after having read through this
troubleshooting section, please call your local Farm King dealer. Before you call, please have this
Operator And Parts Manual and the serial number of your machine at hand.
PROBLEM CAUSE CORRECTION
Cannot start augers.
Plugged auger or obstruction.
Shutoff tractor and disconnect the
PTO. Remove obstruction.
Bearing failure.
Check bearings and replace if
required.
Grain flow is too fast. Discharge gate(s) open too far.
Close the gate(s) to allow a slower
grain flow to the hopper / intake
auger.
Grain flow is too slow.
Discharge gate(s) not open
enough.
Open the gate(s) to allow a faster
grain flow to the hopper intake auger.
Tractor RPM set to low. Raise tractor RPM to proper setting.
Unit will not extend or
retract completely.
Chainbox shaft is not aligned
properly.
Align the splined shaft so that it
is centered. See “Chainbox Shaft
Adjustment” on page 25.
To Next Page
Loading...
