To Next Page
K
Katelyn JonesSep 10, 2025
Why is my FARM-MAXX FTL Farm Equipment soil texture too fine?
- TTerry FrostSep 10, 2025
If the soil texture is too fine, the rear board may be too low, so raise it. If the ground speed is too slow, increase it.
Why is my FARM-MAXX FTL Farm Equipment soil texture too fine?
If the soil texture is too fine, the rear board may be too low, so raise it. If the ground speed is too slow, increase it.
What to do if my FARM-MAXX FTL is skipping on the ground or leaving crop residue?
If your tiller is skipping or leaving crop residue, ensure the blades are installed correctly. If there is any debris entangled in the blades or rotor, clear it. If the ground speed is too fast, reduce it. If the soil is too hard, reduce ground speed and till in more steps.
Why is my FARM-MAXX FTL driveline vibrating?
Driveline vibration can be caused by a worn drive shaft, which would need replacing. Ensure the machine isn't lifted too high; lower it and readjust the tractor lift stop. Also, check for any debris wrapped on the rotor and remove it.
What to do if my FARM-MAXX FTL Farm Equipment machine skips or leaves crop residue?
If your machine is skipping or leaving crop residue, the blades may be badly worn and need replacing. The slip clutch might also be slipping, so adjust it or reduce the load. If the ground speed is too fast for the conditions, reduce it.
What to do if my FARM-MAXX FTL rotor stops turning?
If the rotor stops turning, the slip clutch may be slipping; reduce the load to the tiller or adjust the slip clutch. Alternatively, there may be a broken chain in the chain box; repair the broken link.
Why is my FARM-MAXX FTL Farm Equipment gearbox overheating?
Gearbox overheating could be due to a low oil level, in which case you should add oil. It could also be caused by hard soil; try reducing the ground speed.
Why is there too much load required to the tractor from my FARM-MAXX Farm Equipment?
If there's excessive load required by the tractor, the working depth might be excessive, so lower the skids. Also, the PTO speed could be too high, so reduce it.
Why is there a noticeable and constant gearbox/transmission case noise in my FARM-MAXX FTL Farm Equipment?
A constant noise from the gearbox or transmission case could be due to a low oil level, so add oil to the gearbox/transmission case. It could also be caused by worn gears, in which case you should replace them.
Why is my FARM-MAXX Farm Equipment tillage not uniform?
Non-uniform tillage can occur if the blades are worn or damaged and need replacement. Ensure the skids are aligned. If the tiller's left side is not leveled with the right side, adjust the tractor's 3-point arms.
Why does my FARM-MAXX FTL tiller choke up with soil?
If the tiller is choking up with soil, the blades might be worn or bent, so replace them. Make sure the tines are installed correctly. If the rear board is too low, raise it. Also, if the soil is too wet, wait until it dries.
General| Brand | FARM-MAXX |
|---|---|
| Model | FTL Series |
| Category | Farm Equipment |
| Language | English |