A.4.9.2
Tracking System and Work Computer (NOT AVALIABLE IN AUSTRALIA)
A.4.9.3
In-Box Mixer
Work computer is a software controlled
electronic unit transmitting the;
Instant moving speed (km/h) and
Total work done
information needed during seeding to operator.
Work computer also has the functionality of controlling the
automatic tracking operation.
For detailed information on the work computer and
tracking system use: (Refer to C.13. Tracking and Use
of Work Computer)
The fluidity of some seeds such as barley with
awn and oat is low. This situation causes flowing
problems by forming a bridge in the throat zone
where the seeds in the box reach the hoppers.
Your grain drill is equipped with a mixer
(optional) to avoid aforementioned problem. The
mixer shaft is driven by the seed transmission
and rotates at low speed and enables the
mobilization of the seed in the hopper’s throat
section. Hence, the bridge formation problem
seen in the seeds with low fluidity is prevented.
The mixer is an optional part and can be
included in any drill later. Also, it can be
disabled when not required.
To Next Page
Loading...