Why are the water temperature and flow volume sometimes unsteady in my FarmTek MWH-180?
Water temperature and flow volume may fluctuate if hot water is used at other faucets simultaneously, water pressure changes occur, or gas regulator fluctuates.
Why does white steam come out from the exhaust outlet of my FarmTek Water Heater?
This occurs because the exhaust gas contains a lot of vapor which turns white when it contacts cold air.
Why does the blower keep running for a while after I shut off the hot water faucet on my FarmTek MWH-180 Water Heater?
The blower continues to run for about 65 seconds after you turn off the hot water faucet to discharge the exhaust gas in the combustion chamber.
Why does the hot water flow volume fluctuate on my FarmTek MWH-180, even at the same set temperature?
The hot water flow volume may fluctuate due to differences in water supply temperature or if the water is supplied by a well with pump pressure fluctuations.
Why does the water temperature at the faucet vary from the displayed temperature on the remote controller of my FarmTek MWH-180?
The hot water temperature may vary from the set temperature due to the climate, plumbing length, or water flow.
Why does the surface of the remote controller of my FarmTek MWH-180 feel warm?
The remote controller feels warm because of the display screen light and the electronic circuit being activated even when the switch is off. This generates heat.
Why does the hot water from my FarmTek Water Heater look white?
Air dissolved in the water is separated and appears white.
Why is hot water with the desired temperature not available immediately when I turn on the faucet for my FarmTek Water Heater?
It takes a little time to reach the set temperature because of the residual water in the pipe and the distance between the unit and the faucet.
How to fix a FarmTek Water Heater that is hard to ignite at the initial attempts?
Shut the hot water supply faucet and open it again. Repeat this process, because there might be air in the gas pipe.
What to do if hot water does not flow from my FarmTek MWH-180, even when the faucet is open?
Turn the faucet further to increase the water volume.
Critical safety information regarding fire, explosion, and gas leaks to prevent injury or death.
Explains the meaning of danger, warning, and caution symbols used in the manual.
Addresses risks associated with vent pipes and gas leaks, and response actions.
Provides guidance on preventing scalding and actions during emergencies.
Covers safety regarding children, flammables, piping, and placement.
Details electrical grounding, handling hot parts, and environmental considerations.
Lists error codes, their causes, and recommended remedies for faults.
Outlines safety classifications (Danger, Warning, Caution) and installation restrictions.
Covers unit suitability checks, minimum clearances, and ventilation requirements.
Details wall mounting, floor drainage, and proper location considerations.
Addresses fire safety, appliance suitability, chemical exposure, and pressure relief valve.
Provides detailed steps for horizontal and horizontal extended vent installations.
Details the procedure for installing horizontal extended vent systems.
Guides on vertical installation, roof pitch, and roof flashing procedures.
Emphasizes grounding, wiring errors, and power disconnection before work.
Emphasizes safety and lists parts needed for natural gas to propane conversion.
Details damper replacement and initial DIP switch adjustments for gas type.
General| Category | Water Heater |
|---|---|
| Model | MWH-180 |
| Protection | IPX4 |
| Frequency | 50 Hz |
| Material | Stainless Steel |
To Next Page