FastCap ChopShop - Tile Clamp Accessory Assembly and Mounting; Securing the Tile Clamp; Adjusting Clamp Position; Attaching Saw Hood to Clamp

FastCap LLC • 888-443-3748 • www.fastcap.com
WE INNOVATE
Assembly and mounting
instructions for Tile
Clamp accessory
To use Tile Clamp accessory:
• Drill holes into the stand or table with the drill bit that is
included. Use at least two of the screws that are included
with each clamp to secure it in place (C).
• Adjust accessory hole (A) to an upright position and clamp
down using handle (B).
• Now, simply place the ChopShop Saw Hood accessory rods
(D) into the accessory hole on tile clamp. Now you are ready
to go.
A
D
B
C