Favero ASSIOMA DUO - Tightening Pedals to Crank-Arms; Cleat and Shoe Setup; Cleat Fixing Procedure

5
FAVERO Electronics - 0259-0902A Assioma user manual _Rev12 - EN-IT-DE
ENGLISH
8.2. Tightening the pedals
Before tightening the pedals, apply a thin layer of grease to the pedal axle thread.
Tighten the pedal to the crank-arm using the supplied 8 mm hexagonal wrench at a
tightening torque of about 35-40 Nm (25-30 ft lb), a standard torque for the tightening
of many pedals. If the crank-arm producer species a different tightening torque,
apply it.
Pay attention to the rotation direction:
• Tighten the left pedal
counter-clockwise
(facing the pedal).
• Tighten the right pedal
clockwise
(facing the pedal).
9. Cleat xing, shoe position check and cleat release force adjustment
9.1. Cleat xing
Use only the supplied cleats (red cleats, oat 6°) or original LOOK Kéo cleats.
The use of non-original LOOK Kéo compatible cleats may be unsuitable and any
damage to the product will not be covered by the warranty.
To x the cleats, use the supplied screws and washers.
Align the cleat in the preferred position and tighten the screws with a tightening force
of 4÷6 Nm (3÷4.5 ft lb), as for most of the cleats on the market.