FAVI universal mount instructions, LED-2 projector.
Before you begin, please make sure you have the following tools on hand:
● Socket driver with an 8mm socket
● 7mm wrench and socket
An Allen wrench is also required. Your mount comes supplied with this already.
Step 1: Loosen the four 8mm bolts located in the middle of the leg assembly. Then use
the Allen wrench to loosen the leg bolts. Do not remove any of the bolts yet.
Step 2: Remove the 8 MM bolt for the top right leg, then remove the leg:
To Next Page
Need help?
General
