Need help?Do you have a question about the Fbt MaxX 2a and is the answer not in the manual?
General| Configuration | 2-way |
|---|---|
| Frequency Response | 50 Hz - 20 kHz |
| Dispersion | 90° x 60° |
| Input Impedance | 22 kOhm |
| Input Connectors | XLR, Jack |
| Type | Active Speaker |
| LF Driver | 12" |
| HF Driver | 1.4" |
| Woofer Size | 12" |
| Tweeter Size | 1.4 inch |
System utilizes 4 adapters 'B' for stacking speaker units.
M10 threaded inserts enable secure wall/ceiling mounting with adjustable orientation.
Details the specific accessory (mod.BOX102) for vertical wall mounting.
Overview of the new FBTMaxX generation, detailing features, construction, and benefits.
Comparison highlighting key differences between the MaxX 2a (bi-amplified) and MaxX 2 (passive) models.
Explains IN/OUT sockets and the LINE/MIC input switch functionality.
Covers Gain, Volume potentiometers, and HIGH/MID/LOW tone controls.
Details the ADAP protection and PWR status LED.
Operation of the GND LIFT switch for signal ground isolation.
Technical data on speaker type (2-way) and nominal impedance.
Specifications for built-in amplifier and frequency response range.
Information on Maximum SPL, sensitivity, and driver/woofer sizes.
Key physical measurements (WxHxD) and weight of the speaker.
Listing of the available input connector types for the speaker.
Illustrates connecting speakers to a powered mixer.
Shows connection with an external power amplifier and mixer.
Example setup with subwoofers and satellite speakers.
Basic setup for connecting a microphone and two speakers.
Basic connection of mixer L/R outputs directly to speaker inputs.
How to connect multiple FBTMaxX 2a speakers in series.
Setup combining speakers with filtered subwoofers.
Detailed wiring diagram for the combo input connector.
Wiring information for the stereo jack input connector.
Wiring specifications for the Speakon speaker connector.
To Next Page
