EN
08
Step 3-a: Start your car.
If you failed to start your car, you need to disconnect the battery clamp from the vehicle and the jump starter.
Wait for at least 30 seconds, then try again.If you failed to start your car after 2 attempts, you can use the force start
function. See step 3-b.
Step 3-b(optional): Force start function. First please make sure that the clamps are connected to the correct polarity
battery terminal. Then, press and hold the force start button for 3 seconds.
When the indicator light of the smart clamp is solid green, you need to start the vehicle within 30s.
Step 4: Once your car is started, remove the battery clamp from the car-battery and the jump starter within 30
seconds.
support@fconegy.cn
To Next Page
Loading...