EN
07
Step 1: Insert the plug of the smart battery clamp completely into the jump starter. If the green and red light indicators
on the battery clamp are flashing alternately, you are safe to move on to to the next step.
Step 2: Connect the red clamp to the positive terminal(+) of the car battery and connect the black clamp to the
negative terminal(-) of the car battery. If the green and red light indicators on the battery clamp are flashing
alternately, you are safe to move on to the next step.
However, if the red indicator light is on:
1.The battery clamp may be connected in reverse. If so, you need to disconnect the battery clamp from the vehicle
and the jump starter.
2.Adjust the clamps for maximum contact with the battery terminals
Jump start your car
NOTE: ▪ This product is for 12V car (up to 7.0L petrol or 5.0L diesel engine) only.
▪ Check to make sure that battery level is above 50% before you use it to jump start your car.
support@fconegy.cn
To Next Page
Loading...