FE PETRO STP-DHI - Important Safety Messages

2
Important Safety Messages
FE Petro equipment is designed to be used to pump volatile hydrocarbon liquids such as gasoline and diesel fuel.
Installing or working on this equipment means working in an environment in which these highly ammable liquids are
present. This presents a risk of severe injury or death if these instructions and standard industry practices are not
followed. Read and follow this entire instruction booklet before installing or working on this equipment.
As you read these instructions, watch for the following safety symbols:
Warning
This symbol identies a potentially hazardous situation which, if the instructions that follow it are not
adhered to, could result in death or serious bodily injury.
Caution
This symbol identies a potentially hazardous situation which, if the instructions that follow it are not
adhered to, could result in serious property damage, including possible environmental contamination
as a result of the leakage of fuel from the equipment.
Warning
Highly ammable vapors may be present in the environment in which this equipment is being
installed or serviced. Do not smoke while working on or near this equipment. Use only non-
sparking tools. Failure to follow this instruction could result in serious re or explosion.
Warning
Follow all federal, state, and local laws governing the installation of this product and its
associated systems. When no other regulations apply, follow NFPA codes 30, 30A, and 70
from the National Fire Protection Association. Failure to follow these codes could result in
severe injury, death, serious property damage, and/or environmental contamination.
Warning
If the electrical circuit breakers are accidentally turned on while the Dispenser Hook Isolator
(DHI) is being installed, potentially lethal electrical shock hazards will be present during DHI
installation, which could result in death or serious injury. ALWAYS tag and lock breakers so
they are not turned on accidentally.
Installer: This instruction booklet MUST be left with the owner of the service station at which the equipment is
being installed.
Station Owner: Retain these instructions for future use and provide them to persons servicing or removing this
equipment.