Federal Signal Corporation Integrity Series User Manual

Federal Signal Corporation Integrity Series

44 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

25500063

REV. B2 0820

© Copyright 2014-2020 Federal Signal Corporation

Installation, Maintenance,

and Service Manual

Integrity Light Bar

Table of Contents

Questions and Answers:

W
Whitney GatesAug 12, 2025
Why does my Federal Signal Corporation Integrity light bar turn off when the Flash Takedown/Alley lights turn on?
- K
  Kayla KingAug 12, 2025
  This may happen if the vehicle battery is not fully charged. To resolve this, ensure the vehicle battery is fully charged. Also, verify that the light bar's red power line (+BAT) and black ground-power line (–GND) are properly connected to a good, fully charged 12-volt battery. Check the red power line (+BAT) and the black ground-power line (–GND) connections in the light bar and vehicle.
C
Christine AndersonAug 19, 2025
What to do if an LED module does not light on my Federal Signal Corporation Integrity Lighting Equipment?
- H
  Hannah CoxSep 12, 2025
  To troubleshoot, swap the LED board with a known good board to see if the original board is faulty. Also, check the cable connections from the light bar controller to the LED ROC board. If it's a rear module, check the SignalMaster® connections.
J
Justin DonovanAug 27, 2025
What to do if half of an LED module does not light on my Federal Signal Corporation Integrity?
- N
  natalieperkinsAug 27, 2025
  If half of an LED module isn't lighting up, replace the ROC board that the LED is on.

Federal Signal Corporation Integrity Series Specifications

General

Type	LED Lightbar
Light Source	LED
Operating Temperature	-40°F to +160°F (-40°C to +71°C)
IP Rating	IP67
LED Life	100, 000 hours
Ingress Protection Rating	IP67
Mounting	Roof, Grille, Deck
Voltage	12V DC
Certifications	ECE R65
Light Output	Varies by model
Flash Patterns	Multiple
Housing Material	Polycarbonate
Mounting Options	Roof, Grille, Deck

Summary

Safety Messages

Safety Message to Installers and Service Personnel of Warning Lights

Safety instructions for those installing and servicing warning lights.

Safety Messages to Operators of Federal Signal Sound/Light Systems

Safety instructions for operators of warning systems.

Wiring the Integrity Light Bar in the Vehicle

Planning the Electrical Installation

Steps to plan the electrical installation of the light bar.

Connecting Power to the Light Bar

Instructions for connecting power to the light bar.

Installing the Serial Interface Module

Procedures for mounting and wiring the Serial Interface Module.

Wiring the Serial Interface Module

Overview of default settings and wiring for the Serial Interface Module.

SignalMaster Connections

How to connect and configure SignalMaster operation.

Maintaining and Servicing the Integrity

Resetting the Controller

Troubleshooting the Light Bar

Assistance for common problems and solutions for the light bar.

Related product manuals

STREAMLINE LP3M

Preview: Navigator Lightbar

Navigator Lightbar

Preview: VITALITE 121

Preview: Valor VALR44